Heated oil phase
26.5% oils of your choice
Heated water phase
5% pottasium hydroxide
15% distilled water
Cool down phase
2%fragrance
1.5%germal plus
Dillution phase
45% distilled water
5% glycerine
PROCEDURE
Pour the potassium hydroxide into the water while stirring gently set aside to cool down.
Pour your oil or oils into a crook pot(if you don't have one ,use a normal pot )
Allow the oil to heat up in the pot.
Pour the pottasium hydroxide solution into the oils.Heat hepls to emulsify the caustic solution with the oils .so you don't need to let your solution cool down.
As soon as the oils are all melted and the solution turns clear,you can mix.
Stick blend to trace(a certain thickness consistency) sometimes getting to trace with liquid soap can take a while
Stick blend for about 10 mins
Keep your pot on high heat because heat helps.
Come back after 10 mins and stick blend again it would have gotten to trace again by now but if you still aren't there leave for 10 mins again and come back to try again.
You'll get there eventually .
Cover the pot and let it cool for 30 mins . Don't stir . The soap puffy and Rise a bit. Some of it will turn translucent
After 30 mins , stir really well.
Let it cook for another hour or so until most of the soap has turned translucent.
It helps to not stir , because then you can see which soap has turned translucent and which hasn't.
Boil the 900ml water and 100ml glycerin in another pot.
Turn off the heat and cover hours for that so you can stir it occasionally.
It takes time for the liquid soap paste to absorb all of the water once diluted ,you can add frangrance.
Comments
Post a Comment